Re: bass drum tune [MusiciansBooks.com Review]

Re: bass drum tune

Submitted By Tony () on December 13, 2002 at 12:20:47:

In Reply to: bass drum tune posted by frank laubinger on October 31, 2002 at 21:12:40:

: I HAVE A 22X16 LUDWIG BASS WITH BATTER HEAD AND FRONT WITH ABOUT 13 INCH CUT OUT I TOOK THE FELT STRIP OUT AND TRYING DIFFRENT SIZE PILLOWS IN DRUM WHATS THE BEST WAY TO GET A NICE LOW DEEP THUD SOUND WITH OUT LOSEING THE TONE IT SEEMS LIKE ITS TO DEAD OR TO BOOMY I WOULD LIKE TO GET THAT NICE LOW THUD WITH OUT LOSEING IT. THANK YOU

Take the pillows out of your drum and put them back in the closet. Buy yourself an Aquarian Impact III bass drum head (beater side) and a heavy head of you choice for the front. Make a 3" at approximately 8 o clock off dead center. Tighten the front head to thumb tightness and the beater head the same. If the tone is too much, place small rings of tape inside the front head 2" from the bearing edge. This is a good place to start, you can adjust the heads to get the tone and pitch you want but this will give you the low end you are looking for.

Follow-Ups:

re: 06:00:56 8/03/05 (0)
re: 07:14:53 8/02/05 (0)
re: propecia lose weight 05:09:49 7/04/05 (0)
Re: bass drum tune John C 10:37:33 9/08/03 (0)
Re: bass drum tune John C 10:32:18 9/08/03 (1)
- Rings Rings 12:39:44 7/13/06 (0)

BACK TO REVIEW FORUM

Hot Pick
of the Month

CLICK HERE
Beyond Power Chords, Take Your Guitar Playing to the Next Level!

MUSIC RESOURCES
Music Software
Sheet Music
MusiciansAvailable.com

HITSQUAD
Advertising MediaKit
Privacy Policy
Hitsquad People

POST YOUR COMMENTS ON THIS REVIEW
Name:
E-Mail:
Subject:
Message: : : I HAVE A 22X16 LUDWIG BASS WITH BATTER HEAD AND FRONT WITH ABOUT 13 INCH CUT OUT I TOOK THE FELT STRIP OUT AND TRYING DIFFRENT SIZE PILLOWS IN DRUM WHATS THE BEST WAY TO GET A NICE LOW DEEP THUD SOUND WITH OUT LOSEING THE TONE IT SEEMS LIKE ITS TO DEAD OR TO BOOMY I WOULD LIKE TO GET THAT NICE LOW THUD WITH OUT LOSEING IT. THANK YOU : : Take the pillows out of your drum and put them back in the closet. Buy yourself an Aquarian Impact III bass drum head (beater side) and a heavy head of you choice for the front. Make a 3" at approximately 8 o clock off dead center. Tighten the front head to thumb tightness and the beater head the same. If the tone is too much, place small rings of tape inside the front head 2" from the bearing edge. This is a good place to start, you can adjust the heads to get the tone and pitch you want but this will give you the low end you are looking for.

Home | Search | Returns | Policy | Contact